Correct Operation

The choice of a Cable Granulator depends on the material properties of the types of copper wires and cables. Correct choice can not only improve the working efficiency, but also extend the service life of the machine. The cutting blades are made with Wire Cutting Technique, blades are replaceable for each other. We have different requirements for blades to different types of copper wires.

1). Air-fine Wires, Multi-strands (See Photo) ---------------

When Cable Granulator dealing with Air-fine Wires and Multi-strands fixed blades and rotating blades must be very sharp so that copper wires can be cut and copper granules will be very clean and pure.

2). Single-strand and Single-core Wires (See Below Photos)---------------

When Cable Granulator dealing with Single-strand and Single-core Wires, the rotating blades shall be a little blunt and fixed blades must be sharp. In this case,the spacing between the rotating blades and fixed blades is just able to hold wires but does not touch the cores. The wires are crushed but there will be little copper granules with plastics outside. (Note: if blades are not adjusted in accordance with the requirements, it may cause too many copper clad granules and the separation is not clean,etc.)